# Managing Watches

> List, re-threshold, rename, and remove the wallets you watch.

Every watch has a detail panel with three actions — **💰 Threshold**, **✏️ Rename**, and **🗑 Remove**. Open it from **🐋 My Watches** in the main menu.

## The Watches List

**🐋 My Watches** shows every active watch, three per page, with:

- The nickname (or the shortened address if you sent `skip` at setup).
- The chain.
- The current USD alert threshold.

Tap any entry to open its details.

## The Watch Detail Panel

The detail panel shows the full (shortened) address, the chain, and the current threshold, alongside the management buttons below.

### 💰 Threshold

Tap **💰 Threshold** and enter a new USD floor. Any transfer below this amount is silently ignored. A few sensible starting points:

- **$10,000** — the default. A reasonable signal-to-noise floor for most whales.
- **$100** — for a cold-storage wallet where even a small move is news.
- **$100,000** or more — for a high-volume exchange wallet, to cut routine churn.

The change applies immediately — the next transfer is compared against the new threshold.

### ✏️ Rename

Tap **✏️ Rename** to change the nickname. The old nickname is replaced everywhere it appears.

### 🗑 Remove

Tap **🗑 Remove** and confirm. The watch is deleted, the real-time subscription is torn down, and the `[n/3]` count in the watches list drops — freeing a slot for a new watch.

> **NOTE**
>
> Removing a watch also stops any pending batched alerts for that wallet — you will not receive messages about transfers that happened in the few seconds between the last batch and the removal.